This is going to be in english to have more people to benefit from our experience…
We have:
– One old non-working BitfromBites printer (dual extruder)
– One Ultimaker-board 1.5.7
– One Ulti-controller
– Lots of existing experimental paste-extuder designs such as: http://www.thingiverse.com/thing:28018, http://www.thingiverse.com/thing:25195, http://www.thingiverse.com/thing:15538
Progess so far:
– The BfB is stripped down
– a lasercutted plate protect ans cools the Ultimaker board
– The Ultimaker-board is connected to xyz steppers. They can be moved via prepare/move axis/ via Ulticontroller.
– The board has a MINTEMP Error because there is no thermosensor attached to the board.
– the firmware needs some changes… Steppermotors are different and have a diff. step/mm-ratio
– endstops have div. Positions…
– the printed rotor and coupler seems to be too week and break. scaling in x and y could be a nice solution!
If someone wants to help and/or has some good insights/ideas: you are very welcome!
just leave a comment or write to: roman@zurich.fablab.ch
https://s3-eu-west-1.amazonaws.com/reprapmagazine/RepRapMagazine_Issue_3.pdf
http://eshop.semadeni.com/grosse-spritze-200-ml-polypropylen-pp-06-01-013.html
http://eshop.semadeni.com/katheter-spritze-polypropylen-pp-06-01-014.html
http://eshop.semadeni.com/wund-und-blasenspritze-120-ml-polypropylen-pp-06-01-012.html